Has Miss Fern un-plugged the stair lift again? Al --- Jesse Livingston <fernj1@xxxxxxxxxxxxx> wrote: > I have always reamed my pump bores and used brass > barrels with bronze > plungers. Works for me anyway. There may be > stainless plungers on the > crosshead pumps on my American, but it is in the > basement and I am upstairs, > need I say more? > > Jesse in West Tennessee > > > #1--What materials were used in full sized practice > and WHY cannot the same > material be used in our models? I'm using ground > Stainless in mine and if I > have to replace it after several years, I can do > that. > > #2--WHY must the inside of a pump bore be lapped > instead of just a good > bored or reamed finish? Isn't the rings/packing job > to take up any small > irregularities in the finish of the bore? > > Just the rambling thoughts of a total newbie. > > Al Messer > > This email was cleaned by emailStripper, available > for free from > http://www.papercut.biz/emailStripper.htm > > MODEL ENGINEERING DISCUSSION LIST. > > To UNSUBSCRIBE from this list, send a blank email > to, > modeleng-request@xxxxxxxxxxxxx with the word > "unsubscribe" in the subject line. > __________________________________________________ Do You Yahoo!? Tired of spam? Yahoo! Mail has the best spam protection around http://mail.yahoo.com MODEL ENGINEERING DISCUSSION LIST. To UNSUBSCRIBE from this list, send a blank email to, modeleng-request@xxxxxxxxxxxxx with the word "unsubscribe" in the subject line.