Thanks, Harry. 10,00's of castings? Hmmm----I'll have to check farther, sounds very interesting then. Al --- Harry Wade <hww@xxxxxxxx> wrote: > At 03:13 PM 2/20/06 -0800, you wrote: > >I'm interested in knowing more about the Reeves' > pump casting you used as > a basis. Do they have an on line catalogue? - Al > > Al, > They do, but you won't find a drawing/photo > there or in their paper > catalogue. Theye have 10,000's of castings so > that's much too fine a level > of detail for them to show. I can send you a > drawing of the pump but > there's nothing partcilarly unique about it, it's > one of dozens of similar > pump castings that Reeves and other suppliers sell, > this one just happens > to be for this particular loco (Bridget) and I just > happened to have a > spare casting which I found was a drop-in fit. I > believe it's cast bronze > rather than gunmetal, and I could easily have > fabricated it from 660 bronze > bar if I'd needed to. I haven't been updating my > web site progress photos > lately so it's not posted there yet. > > Regards, > Harry > > MODEL ENGINEERING DISCUSSION LIST. > > To UNSUBSCRIBE from this list, send a blank email > to, > modeleng-request@xxxxxxxxxxxxx with the word > "unsubscribe" in the subject line. > __________________________________________________ Do You Yahoo!? Tired of spam? Yahoo! Mail has the best spam protection around http://mail.yahoo.com MODEL ENGINEERING DISCUSSION LIST. To UNSUBSCRIBE from this list, send a blank email to, modeleng-request@xxxxxxxxxxxxx with the word "unsubscribe" in the subject line.