Hi all If you are giong to build a hot wire cutter and need a powrer supply; CompUSA is selling an ATX computer supply for $1.99 after rebates Starts at $29.99 then instant $7.00 off and $21.00 mail in. I dont know how good such a supply is for the purpuse but have read in threads that they are used. To work rather well; it would be good to have DC outputs of about 12v- 6amp for wing core cutting set ups and 5/6v-6amp for fff cutting. I don't know the available outputs on these. Some of you computer geeks should know. There are probably a lot of free ones laying around if you know where to find them. An AT power supply should also work depending on available output V/As. Phil ___________________________________________________________________________ You are a member of the lektrik_flyers listserv. You became a member of this listserv by either directly subscribing or being recommended for subscription by a fellow member. If you no longer wish to be a member of this listserv, please follow the link (//www.freelists.org/list/lektrik_flyers) and follow the onscreen prompts to be removed from this list. Should this not work for you send an email to bbeavers57@xxxxxxxxx and supply the email address you wish to have removed from the listserv, and this will be done at the earliest available opportunity. Visit our website at http://users.tcworks.net/~bbeavers/. Thank you and we hope you continue to enjoy being a member of the lektrik flyers.