Hey Jack; well, in a message, when I speed up a message using alt ctrl page down, obviously the rate of speed is faster. when I press escape, to get out of the message, I just press screen refresh, insert escape, my voice settings go back to normal. ----- Original Message ----- From: "Jack Lowe" <akronjack1982@xxxxxxxxxxxxx> To: <jfw@xxxxxxxxxxxxx> Sent: Wednesday, March 09, 2005 4:06 PM Subject: Speeding up jaws on the fly Hey All, I know that when in a message, I can hit page down to make jaws read faster, or page up to make it slow down. What I want to know is... Is there a way to make jaws go back to my voice rate settings? It seems that the only way I can get Jaws to reset itself is to alt tab out of that window, then back into it again. If that's how I have to do it, that's fine. I just wondered if there was a key command that brings back my default settings for the reading rate that I have as the default. Thanks. Jack -- To post a message to the list, send it to jfw@xxxxxxxxxxxxx To unsubscribe from this mailing list, send a message to jfw-request@xxxxxxxxxxxxx with the word unsubscribe in the subject line. Archives located at: //www.freelists.org/archives/jfw If you have any concerns about the list, post received from the list, or the way the list is being run, do not post them to the list. Rather contact the list owner at jfw-admins@xxxxxxxxxxxxxx -- To post a message to the list, send it to jfw@xxxxxxxxxxxxx To unsubscribe from this mailing list, send a message to jfw-request@xxxxxxxxxxxxx with the word unsubscribe in the subject line. Archives located at: //www.freelists.org/archives/jfw If you have any concerns about the list, post received from the list, or the way the list is being run, do not post them to the list. Rather contact the list owner at jfw-admins@xxxxxxxxxxxxxx