[PCB_FORUM] Re: dynamic planes
- From: "Gerry Meier" <gerry.meier@xxxxxxxxxxxxxx>
- To: <icu-pcb-forum@xxxxxxxxxxxxx>
- Date: Wed, 16 Jun 2004 09:02:00 -0400
Paul,
If you look at the available pin properties there is one called
DYN_CLEARANCE_OVERSIZE that you can set on an individual pin basis.
Check these out,
Gerry
Gerry Meier
Sr. PCB Designer
Freedom CAD Services, Inc.
Voice: (603) 864-1300 x1350
Alt. Voice: (386) 753-0048
Email: gerry.meier@xxxxxxxxxxxxxx
visit our website at< http://www.freedomcad.com <http://www.freedomcad.com/>
-----Original Message-----
From: Paul A. Simonelli [mailto:simonelli_pa@xxxxxxxxxxxx]
Sent: Wednesday, June 16, 2004 8:52 AM
To: icu-pcb-forum@xxxxxxxxxxxxx
Subject: [PCB_FORUM] dynamic planes
To All,
I have a v14.2 board with numerous planes. All of these planes have many
manual voids that are bigger than the default or drc voids. This was done to
meet creepage spacings. When brought into v15.1 and changed to dynamic
shapes the larger voids change to the global parameter settings. Is there a
way to retain the larger voids or do I have add them manually again? I'm
trying to avoid doing this through constraint manager.
Paul Simonelli, Senior PCB Design Engineer
Pannaway Technologies | v: 603.766.5113 | e: simonelli_pa@xxxxxxxxxxxx
<mailto:%20simonelli_pa@xxxxxxxxxxxx>
=========================================
Other related posts:
