Go into global shape parameters and play around with the min Aperture gap and the line width. I don't have a formula for success. But, I've seen this before and this is what I did to fix it. Richard Weinberg Agere Systems -----Original Message----- From: icu-pcb-forum-bounce@xxxxxxxxxxxxx [mailto:icu-pcb-forum-bounce@xxxxxxxxxxxxx] On Behalf Of Gene Carman Sent: Wednesday, May 17, 2006 2:26 PM To: icu-pcb-forum@xxxxxxxxxxxxx Subject: [PCB_FORUM] Chasing DRCs... Vias to shape. Using 15.2, not ready to move to 15.5. Working on a design that has fill (shapes) on every layer (mixed signal analog). Very frustrated that Allegro is not clearing away fill from all the vias, but is smart enough to make DRCs where the problem exists (D'oh!). But the odd thing is that when I do a local remove of the fill to correct the DRC, it jumps to another via. I HAVE to CHASE the DRCs... What a frustrating "game." I have checked the database... often. Anyone else see anything like this? I am using dynamic shapes in RS-274 mode. Running in Win2K. ----------------------------------------------------------- To subscribe/unsubscribe: Send a message to icu-pcb-forum-request@xxxxxxxxxxxxx with a subject of subscribe or unsubscribe To view the archives of this list go to //www.freelists.org/archives/icu-pcb-forum/ Problems or Questions: Send an email to icu-pcb-forum-admins@xxxxxxxxxxxxx ----------------------------------------------------------- ----------------------------------------------------------- To subscribe/unsubscribe: Send a message to icu-pcb-forum-request@xxxxxxxxxxxxx with a subject of subscribe or unsubscribe To view the archives of this list go to //www.freelists.org/archives/icu-pcb-forum/ Problems or Questions: Send an email to icu-pcb-forum-admins@xxxxxxxxxxxxx -----------------------------------------------------------