If it's a round off problem I'm putting a 0.1 mils oversize value for the clearances in shape parameter and it's solving my drcs. Regards Samuel -----Original Message----- From: icu-pcb-forum-bounce@xxxxxxxxxxxxx [mailto:icu-pcb-forum-bounce@xxxxxxxxxxxxx] On Behalf Of chris.ball@xxxxxxxxx Sent: Wednesday, May 17, 2006 2:16 PM To: icu-pcb-forum@xxxxxxxxxxxxx Subject: [PCB_FORUM] Re: Chasing DRCs... Vias to shape. C A D E N C E Chasing Around Drc's Essentially Neverending Can't Explain -Chris "Gene Carman" <gcarman@xxxxxxxxxxxxxxx> To: <icu-pcb-forum@xxxxxxxxxxxxx> Sent by: cc: icu-pcb-forum-bounce@freel Subject: [PCB_FORUM] Chasing DRCs... Vias to shape. ists.org 05/17/2006 02:25 PM Please respond to icu-pcb-forum Using 15.2, not ready to move to 15.5. Working on a design that has fill (shapes) on every layer (mixed signal analog). Very frustrated that Allegro is not clearing away fill from all the vias, but is smart enough to make DRCs where the problem exists (D'oh!). But the odd thing is that when I do a local remove of the fill to correct the DRC, it jumps to another via. I HAVE to CHASE the DRCs... What a frustrating "game." I have checked the database... often. Anyone else see anything like this? I am using dynamic shapes in RS-274 mode. Running in Win2K. ----------------------------------------------------------- To subscribe/unsubscribe: Send a message to icu-pcb-forum-request@xxxxxxxxxxxxx with a subject of subscribe or unsubscribe To view the archives of this list go to //www.freelists.org/archives/icu-pcb-forum/ Problems or Questions: Send an email to icu-pcb-forum-admins@xxxxxxxxxxxxx ----------------------------------------------------------- "This e-mail message is intended only for the use of the intended recipient(s). The information contained therein may be confidential or privileged, and its disclosure or reproduction is strictly prohibited. If you are not the intended recipient, please return it immediately to its sender at the above address and destroy it." ----------------------------------------------------------- To subscribe/unsubscribe: Send a message to icu-pcb-forum-request@xxxxxxxxxxxxx with a subject of subscribe or unsubscribe To view the archives of this list go to //www.freelists.org/archives/icu-pcb-forum/ Problems or Questions: Send an email to icu-pcb-forum-admins@xxxxxxxxxxxxx ----------------------------------------------------------- ----------------------------------------------------------- To subscribe/unsubscribe: Send a message to icu-pcb-forum-request@xxxxxxxxxxxxx with a subject of subscribe or unsubscribe To view the archives of this list go to //www.freelists.org/archives/icu-pcb-forum/ Problems or Questions: Send an email to icu-pcb-forum-admins@xxxxxxxxxxxxx -----------------------------------------------------------