Thanks,
I picked one up from craigslist last night, and hope it works for my
application.
Thanks for the info.
Neil
On Sun, Jul 26, 2015 at 11:54 PM, Joachim Hall <jjoachimhall@xxxxxxxxx>
wrote:
I've got a good 1/2 horse 120 volt motor from a garage door opener. It's
fairly low rpm though. Only 900 rpm. I'm guessing you'd need a bit more
than that. I'm also not sure it's rated for continues use. But that
wouldn't be too hard to find out... Might be ok though since it's a little
over rated. I know the shop has a lot of motors but I don't recall seeing
very many AC motors.
Best,
-Joachim
On Jul 24, 2015 7:59 PM, "Neil Cox" <neildenniscox@xxxxxxxxx> wrote:
Hey everyone,
Does HackPGH have any 110, single phase, 1/3 horsepower or slightly
higher motors laying around?
I recently bought an industrial sewing machine with a 220, 3 phase,
1/3 motor and would like to swap it out with a 110 single phase that I
can plug into a normal wall outlet.
I am more then willing to donate the 220 3 phase in return.
Any info would be greatly appreciated.
Thanks guys!
Neil
