Jeff, Check the document B0193DF "Display Commands" on page 50 for the "e" command. May be this could help you. Regards, Ignacio -----Mensaje original----- De: foxboro-bounce@xxxxxxxxxxxxx [mailto:foxboro-bounce@xxxxxxxxxxxxx] En nombre de Jeff Hurt Enviado el: Jueves, 08 de Abril de 2010 11:44 Para: foxboro@xxxxxxxxxxxxx Asunto: Re: [foxboro] dmcmd question Here's to clarify the poor formatting from my previous email: close -all == 'DUCT_BNR:XI1138.CIN' 1 ov \opt\olean\ovl\FC0810.fdf -l LR != 'DUCT_BNR:XI1138.CIN' 1 ov \opt\olean\ovl\FC0918.fdf -l LR Thanks --- On Thu, 4/8/10, Jeff Hurt <thehurtman@xxxxxxxxx> wrote: From: Jeff Hurt <thehurtman@xxxxxxxxx> Subject: dmcmd question To: foxboro@xxxxxxxxxxxxx Date: Thursday, April 8, 2010, 9:21 AM I'm hoping someone can give me some help with this foxdraw question. I'm trying to open an overlay dependent upon the state of a CIN. It never executes the equal statement. close -all== 'DUCT_BNR:XI1138.CIN' 1 ov \opt\olean\ovl\FC0810.fdf -l LR!= 'DUCT_BNR:XI1138.CIN' 1 ov \opt\olean\ovl\FC0918.fdf -l LR Thanks,Jeff _______________________________________________________________________ This mailing list is neither sponsored nor endorsed by Invensys Process Systems (formerly The Foxboro Company). Use the info you obtain here at your own risks. Read http://www.thecassandraproject.org/disclaimer.html foxboro mailing list: //www.freelists.org/list/foxboro to subscribe: mailto:foxboro-request@xxxxxxxxxxxxx?subject=join to unsubscribe: mailto:foxboro-request@xxxxxxxxxxxxx?subject=leave _______________________________________________________________________ This mailing list is neither sponsored nor endorsed by Invensys Process Systems (formerly The Foxboro Company). Use the info you obtain here at your own risks. Read http://www.thecassandraproject.org/disclaimer.html foxboro mailing list: //www.freelists.org/list/foxboro to subscribe: mailto:foxboro-request@xxxxxxxxxxxxx?subject=join to unsubscribe: mailto:foxboro-request@xxxxxxxxxxxxx?subject=leave