[bookport] Re: Copying to Removeable Disk
- From: "Chris G" <chrisg@xxxxxxxxxxxxxxxx>
- To: bookport@xxxxxxxxxxxxx
- Date: Wed, 23 Jun 2004 22:26:36 -0400
you need to run the bp firmware file when your bp is connected, it's a=
setup wizard.
aventually it'll say finish and prompt you to disconnect your bookport.
*********** REPLY SEPARATOR ***********
On 6/23/2004 at 9:23 PM Dale Lieser wrote:
>Jeremiah:
>
>When I use the send-to menu to copy the bpfw.exe file to, what on my=
system
>is drive G, the computer prompts me to insert a disk into that drive. I
>disconnected, then reconnected. Of course Book Port Transfer came up, but
>I
>closed it. My sighted wife says that she could see that the firmware file
>was copying as Book Port Transfer was doing its automatic load.
>
>After disconnecting again, I issued the 1+3+*+# command, and nothing
>happened, though I waited for more than 15 seconds. Any suggestions as to
>what I can try? A browse on the BP shows the .exe file is indeed on the
>flash card.
>
>Dale
Other related posts:
