Thanks for the measurements, Don.Troy
-----Original Message-----
From: Don Anderson <donandersonracing@xxxxxxxxx>
To: BobsyTalk <bobsy_talk@xxxxxxxxxxxxx>
Sent: Wed, Mar 20, 2019 1:15 pm
Subject: A Bobsy Talk Email: Re: seats
Troy,The Bobsy Fiberglass seat is 17" wide, including the rolled edge flange
that could be trimmed.As seen in the photo of my SR3, 2 fit side by side, with
upholstery over the rolled edge.Don
On Wed, Mar 20, 2019 at 8:33 AM Redacted sender gonridn2 for DMARC
<dmarc-noreply@xxxxxxxxxxxxx> wrote:
Thanks Don, could you tell me the width of those seats? Trying to see if I can
get a seat into my center-console car.Troy
-----Original Message-----
From: Don Anderson <donandersonracing@xxxxxxxxx>
To: BobsyTalk <bobsy_talk@xxxxxxxxxxxxx>
Sent: Tue, Mar 19, 2019 9:15 pm
Subject: A Bobsy Talk Email: Re: seats
Troy,I have the mold for the original Bobsy SR 3 to 6 fiberglass seats, which
were all the same.They bolt directly to the floor pan with two 1/4" pan head
screws, and to the firewall with two 1/4 screws through an aluminum square tube
spacer to space the top out.Attached is a photo of 2 bare fiberglass seats from
my SR5 (with SR5 mounts, NOT SR3), and the same seats with upholstery installed
in my Bobsy-Porsche SR3. The bolts/screws are under the upholstery.Don
On Tue, Mar 19, 2019 at 8:41 PM Redacted sender gonridn2 for DMARC
<dmarc-noreply@xxxxxxxxxxxxx> wrote:
Can anyone share pics of seats mounted in their SR3? Not the usual bead/foam
seats poured into the cockpit but bolted-in hardshell seats
(fiberglass/aluminum). How did you attach them to the chassis?Troy