Troy,
The Bobsy Fiberglass seat is 17" wide, including the rolled edge flange
that could be trimmed.
As seen in the photo of my SR3, 2 fit side by side, with upholstery over
the rolled edge.
Don
On Wed, Mar 20, 2019 at 8:33 AM Redacted sender gonridn2 for DMARC <
dmarc-noreply@xxxxxxxxxxxxx> wrote:
Thanks Don, could you tell me the width of those seats? Trying to see if I
can get a seat into my center-console car.
Troy
-----Original Message-----
From: Don Anderson <donandersonracing@xxxxxxxxx>
To: BobsyTalk <bobsy_talk@xxxxxxxxxxxxx>
Sent: Tue, Mar 19, 2019 9:15 pm
Subject: A Bobsy Talk Email: Re: seats
Troy,
I have the mold for the original Bobsy SR 3 to 6 fiberglass seats, which
were all the same.
They bolt directly to the floor pan with two 1/4" pan head screws, and to
the firewall with two 1/4 screws through an aluminum square tube spacer to
space the top out.
Attached is a photo of 2 bare fiberglass seats from my SR5 (with SR5
mounts, NOT SR3), and the same seats with upholstery installed in my
Bobsy-Porsche SR3. The bolts/screws are under the upholstery.
Don
On Tue, Mar 19, 2019 at 8:41 PM Redacted sender gonridn2 for DMARC <
dmarc-noreply@xxxxxxxxxxxxx> wrote:
Can anyone share pics of seats mounted in their SR3? Not the usual
bead/foam seats poured into the cockpit but bolted-in hardshell seats
(fiberglass/aluminum). How did you attach them to the chassis?
Troy