[bksvol-discuss] Re: what scanner

  • From: "Robert Jaquiss" <rjaquiss@xxxxxxxxxxxxx>
  • To: <bksvol-discuss@xxxxxxxxxxxxx>
  • Date: Thu, 1 Sep 2005 21:09:59 -0500

Hello:

You are correct, the optimize feature does not work with ADF only scanners. The problem is because of the the way the ADF drivers work. You can use the optimize with the Fujitsu FI4010cu scanner by putting a page on the flatbed, running the optimize function, save the settings, exit K1000, and then restart K1000, load the previously saved settings, and this time put pages in the ADF.

Regards,

Robert Jaquiss


----- Original Message ----- From: "E." <thoth93@xxxxxxxxxxxxx>
To: <bksvol-discuss@xxxxxxxxxxxxx>
Sent: Thursday, September 01, 2005 8:38 PM
Subject: [bksvol-discuss] Re: what scanner


Are you saying the k1000 optimize feature does not work with your scanner? If it does not, do you know the cause is? Just curious.


At 09:34 PM 9/1/2005, you wrote:

Hello:

In response to the comments about the scanner at BookShare, I have just purchased a Canon DR-2580c scanner. It was $714 from Amazon.com. So far, it is working well. Two things to note about this scanner are that it is only a sheet fed device unless you buy the optional flatbed (about $400), and you cannot use the Optimization procedure to test out the various settings. K1000 and K3000 know how to handle the duplex feature of this scanner. More later.

Regards,

Robert Jaquiss






Other related posts:

  1. Home
  2. bksvol-discuss
  3. Archive
  4. 09-2005