Thanks for all the offers, but I had already ordered a finished cable from ScopeGadgets. Tom ---- pulind@xxxxx wrote: > Tom, > > Lynn's right. If it uses standard 4-pin RJ11 connectors, then we have all > the stuff to make a cable. I have 4 conductor flat wire and connectors and a > crimping tool, but I'm not sure there's a full 25 ft of wire (I'm out of town > now, can't check). > > I know it's quite a drive from your place to the ATM meeting, so we could > make a cable and bring it to the SAC meeting on Friday. > > Paul > > > ----- Original Message ----- > From: "Lynn Blackburn" <lynnrb11@xxxxxxxxx> > To: az-observing@xxxxxxxxxxxxx > Sent: Friday, November 23, 2012 1:53:52 PM > Subject: [AZ-Observing] Re: 4-pin Extension Cable > > Tom, If you cannot find one we can make one up at the ATM meeting next� > Tuesday. Lynn > > > ________________________________ > From: Scott Stiers <srstiers@xxxxxxxxx> > To: az-observing@xxxxxxxxxxxxx > Sent: Friday, November 23, 2012 12:40 PM > Subject: [AZ-Observing] Re: 4-pin Extension Cable > > That's the same connector used for telephone handsets.� RJ-22� Try > searching online for that. > Scott R. Stiers > Gilbert, Az > /Astronomy is Looking Up! Music is Gettin' Down!/ > On 11/23/2012 12:30 PM, Tom Polakis wrote: > > I need an extension cord of a length of about 25 feet to run from a > > Celestron hand control to near my computer. They have 25-foot, 4-pin > > 'phone' cables at Radio Shack or Fry's Electronics, but the connector is > > too wide to fit into the small hand control jack. Does anybody know of an > > electronics store in Phoenix that would have the cable I am looking for? > > Thanks. > > -- > > See message header for info on list archives or unsubscribing, and please > > send personal replies to the author, not the list. > > > > > -- > See message header for info on list archives or unsubscribing, and please > send personal replies to the author, not the list. > -- > See message header for info on list archives or unsubscribing, and please > send personal replies to the author, not the list. > > -- > See message header for info on list archives or unsubscribing, and please > send personal replies to the author, not the list. > -- See message header for info on list archives or unsubscribing, and please send personal replies to the author, not the list.