One more suggestion. It woul be nice to see graphics in steps 1-5 And be able to tune-up profile Sent from iPhone On May 15, 2010, at 4:34 PM, "Florian Höch" <lists +argyllcms@xxxxxxxxx> wrote: > That sentence doesn't seem to make sense :) I think you meant > dispcalGUI? Look under the measurement mode combobox, it should show > several modes for the ColorMunki (normal, adaptive, hires, hires > +adaptive. -V would be adaptive). > > Am 11.05.2010 04:08, schrieb adam k: >> I'm not that keen with Argyll command line mode. I plan to use it via >> dispcal. So can you translate -V for me? >> Thank you! >> >> Sent from iPhone >> >> On May 10, 2010, at 9:58 PM, Graeme Gill<graeme@xxxxxxxxxxxxx> >> wrote: >> >>> adam k wrote: >>>> It's a bummer, because I just ordered CM today hoping to get better >>>> monitor >>>> profile than with dtp94. I wish I knew it before I bought it. >>> >>> If you use the -V mode you will get more consistent readings of >>> lower >>> light levels using the Munki, as this will use longer integration >>> times. >>> >>> Graeme Gill. > -- > Florian Höch > http://hoech.net > >