I mean the target has changed and probably Florian has centered the problem. Thank you Marco 2010/9/6 Florian Höch <lists+argyllcms@xxxxxxxxx<lists%2Bargyllcms@xxxxxxxxx> > > Hi, > > Am 06.09.2010 10:10, schrieb Marco N.: > > In DispcalGUI I have set the white point to 6500K Plankian locus. When I >> have start the calibration I have set in the OSD the white point so that >> the deltaE was very low (below 0.5). During calibration the white point >> remains OK and the 3 curves dosn't chang it, but the same white point >> after a profile verification after profile creation is wrong (deltaE >> >3). !?! >> >> At the start of the calibration I chose 6500K Plankian locus that is xy >> 0.3128 0.3292, why during the calibration the target white point change >> in xy 0.3135 0.3236? >> > > I noted theres currently a bug in dispcalGUI, the calculated xy is always > the correlated daylight temp regardless if you chose planckian (also true > for the profile verification). I'll fix this in the next/upcoming version. > The Argyll numbers are correct. > > > Thank you for any consideration >> Marco >> > > Regards > -- > Florian Höch > > >