Hi, Am 06.09.2010 10:10, schrieb Marco N.:
In DispcalGUI I have set the white point to 6500K Plankian locus. When I have start the calibration I have set in the OSD the white point so that the deltaE was very low (below 0.5). During calibration the white point remains OK and the 3 curves dosn't chang it, but the same white point after a profile verification after profile creation is wrong (deltaE >3). !?! At the start of the calibration I chose 6500K Plankian locus that is xy 0.3128 0.3292, why during the calibration the target white point change in xy 0.3135 0.3236?
I noted theres currently a bug in dispcalGUI, the calculated xy is always the correlated daylight temp regardless if you chose planckian (also true for the profile verification). I'll fix this in the next/upcoming version. The Argyll numbers are correct.
Thank you for any consideration Marco
Regards -- Florian Höch