Magnus Wallden wrote:
Targen V111 possible bug, if a optional profile uses, -c xxxxx.icm, see below, if it sets to run for 20 patches, it works, stop here if 500, so the limit here is somthing between.
.........\targen -v -d4 -c s_10.icm -f500 tg_A4_Lid_500
It depends on the exact combination of fixed patches, number of patches and profile. I can't reproduce it unless you send me the profile. A sufficiently badly behaved device response will probably always cause a failure, because it screws up the spatial geometry.
Printcal stops if it use the description, -D
OK, thanks.
Spotread stops after it has shown the diagram -p , ok whitout that option, I think printcal has equal problem.
Each diagnostic plot stops until you hit key in the plot window. [Note there is a currently a bug Windows XP+ where the plot window fails to accept the key hit until you move the window or resize it. This bug will be fixed in the next release.] Graeme Gill.