[argyllcms] V1.1.1 Targen V111 possible bug, and some outher small thing.
- From: Magnus Wallden <magnus.wallden@xxxxxxxxx>
- To: argyllcms@xxxxxxxxxxxxx
- Date: Fri, 7 May 2010 21:26:51 +0200
Hi !
Perhaps this is mention before.
Targen V111 possible bug, if a optional profile uses, -c xxxxx.icm, see
below,
if it sets to run for 20 patches, it works, stop here if 500, so the limit
here is somthing between.
Vista, 3G Ram, 3Gh dual core.
--
.........\targen -v -d4 -c s_10.icm -f500 tg_A4_Lid_500
CMYK test chart
Full spread patches = 500
Ink limit = 311.3% (underlying 311.3%)
Adaptation weights: Device = 0.350, Perceptual = 0.650, Curvature = 1.000
Perceptual cache resolution = 7
Acceleration grid res = 5
There are 1 unique fixed points to add (4 non-unique)
There are 496 far spread points to add
Added 497/497
After seeding points: MinPoint = 13.839, Min = 4.087, Avg. = 19.452, Max =
24.38
4, 2.0 secs
Re-seeding
It 1: Maxmv = 0.156086, MinPoint = 12.059, Min = 4.087, Avg. = 19.684, Max =
26.
756, 2.9 secs.
Re-seeding
It 2: Maxmv = 0.140941, MinPoint = 7.614, Min = 4.087, Avg. = 19.741, Max =
26.4
30, 2.6 secs.
Re-seeding
targen: Error - Failed to re-seed the veronoi - too many node instertion
failure s ?
---------------------------------
And some smaller thing:
Printcal stops if it use the description, -D
\printcal -v -i %fil_cal_ut_cal% ...ok
Spotread stops after it has shown the diagram -p , ok whitout that
option,
I think printcal has equal problem.
regards
Magnus
Other related posts:
