Hi, Kamil
Thanks for your response. So your suggestion is to just build a profile
without taking any special care about the high OBAs in the paper. Correct?
On Thu, Feb 6, 2020 at 7:47 PM Kamil Tresnak <kamil.tresnak@xxxxxxxxx>
wrote:
Hi Panagiotis,
just a quick note, no matter what parameters and what software you will
use, if your paper is "full of OBA" and viewing conditions will be changing
substantially, you run into the troubles, especially for BW photo.
My personal opinion - it is better to not compensate OBA in full. If you
"omit" some amount of OBA, then your print will look more neutral under
illumination with a small portion of UV, and somewhat colder under
illumination with the standard portion of UV, which is probably more
acceptable for common viewers (my experience, not an absolute one and only
truth).
Best regards
Kamil, Prague
On Thu, Feb 6, 2020 at 1:25 PM Panagiotis Markolefas <
panagiotismarkolefas@xxxxxxxxx> wrote:
Hi!
I want to make with i1pro2 a printer profile for a paper full of OBAs.
The paper is Hahnemuhle Baryta FB 350. It has a strong magenta cast. Most
of the prints will be BW and are going to be seen under various lighting
conditions. What Argyll options should I use for building the profile?
Thanks in advance for any input.
Panagiotis
