It's a good question. I believe the online documentation has a section
devoted to OBA "compensation". I confess I have not had direct experience
with building Argyll profiles for OBA substrates - yet.
/ Roger
From: argyllcms-bounce@xxxxxxxxxxxxx <argyllcms-bounce@xxxxxxxxxxxxx> On
Behalf Of Panagiotis Markolefas
Sent: Thursday, February 6, 2020 7:25 AM
To: argyllcms@xxxxxxxxxxxxx
Subject: [argyllcms] Advice on profiling a high OBA paper
Hi!
I want to make with i1pro2 a printer profile for a paper full of OBAs. The
paper is Hahnemuhle Baryta FB 350. It has a strong magenta cast. Most of the
prints will be BW and are going to be seen under various lighting
conditions. What Argyll options should I use for building the profile?
Thanks in advance for any input.
Panagiotis
