This message was posted by The Embroidery Authority on AmayaUsers.com. PLEASE DO NOT REPLY VIA EMAIL. Instead, respond to the thread on the WEBSITE by clicking here: http://www.amayausers.com/boards/ultimatebb.php?/topic/1/307.html#000009 Dee, Along with all the other information that has been mentioned, I'm thinking the lower thread feed limit might be set too high. Make sure this is on the factory default of 1. Also, are you sewing using tear-a-way backing or possibly only one layer of cut-a-way backing? If so, if your columns are too narrow or your stitch lengths are too short, then you might be cutting holes in the backing as you sew which can trip up the bobbin sensor. Make sure you have your minimum column widths set no less than 10-12 pts. in Design Shop and be sure to use a minimum of two layers of cutaway backing on any fabric that can be considered as "stretchy". Good luck to you, Ed Orantes - Lafayette, LA Melco Tech & Trainer 504-258-6260 =========================================================== The AmayaUsers Mailing List Website: http://www.amayausers.com Discussion Board: http://www.amayausers.com/boards Subscribe/Unsubscribe: http://www.amayausers.com/list ===========================================================