[amayausers.com] Re: Thread Feed Roller change out...
- From: theboards@xxxxxxxxxxxxxx
- To: amayausers@xxxxxxxxxxxxx
- Date: Thu, 1 Dec 2011 03:14:07 UT
This message was posted by Rod or Sharon on AmayaUsers.com. PLEASE DO NOT REPLY
VIA EMAIL. Instead, respond to the thread on the WEBSITE by clicking here:
http://www.amayausers.com/boards/cgi-bin/ultimatebb.cgi?/topic/1/1262.html#000005
Jeff,
I would replace all 16 roller assemblies and start out fresh. While the rollers
are out, use a flashlite and carefully inspect the gears down inside of the
pockets. Make sure there is no thread buildup that would cause dragging and
inspect these gears carefully to see if any of them are fractured around their
hub areas.
Set 1 and 12 roller assemblies aside...this includes the pinch roller, inner
threadfeed roller and the faceplate cover. Use the old roller assemblies as
spares. Your old ones are probably yellow in collor. The new ones are probably
a white-ish color. It is best to keep everything uniform. Lubricate the new
rollers prior to reassembly.
Let us know if the problem gets resolved with the new rollers....
Rod Springer
Amaya Tech & Trainer
===========================================================
The AmayaUsers Mailing List
Website: http://www.amayausers.com
Discussion Board: http://www.amayausers.com/boards
Subscribe/Unsubscribe: http://www.amayausers.com/list
===========================================================
Other related posts:
