Hello,
Rod or Sharon has just posted in the Embroidery / How Do I? forum of AmayaUsers
Discussion Boards under the title of I've had it with the Cap Frame!.
This thread is located at
http://www.amayausers.com/discussion/showthread.php?6141-I-ve-had-it-with-the-Cap-Frame!
Here is the message that has just been posted:
***************
John,
Quote....."Should work fine as I believe the cap driver is the same on the
Amaya's and the XT's. "
As far as the frames being discussed here....yes they will work on any of the
Amaya, XT series, Bravo and the EMT16. As far as being the "cap driver" being
the same.....no. There are differences in the original Amaya, the early XT,
later /older XT', XTS , Bravo, up to the new EMT16.
I am sure that you probably knew this, but thought I would jump in and clarify
the statement.
Version 9 and newer software also has the "Laser alignment" tools that will
help align any garment without the need to "re-hoop" the garment including
caps.....neat tool. For those that have not used it or do not know that it
exists, should by all means check it out. It is the perfect fix for what Trica
has posted about.
Rod Springer
Amaya Tech & Trainer
***************
===========================================================
The AmayaUsers Mailing List
Website: http://www.amayausers.com
Discussion Board: http://www.amayausers.com/boards
Subscribe/Unsubscribe: http://www.amayausers.com/list
===========================================================
