Hello, mikeiarocci22 has just posted in the Embroidery / How Do I? forum of AmayaUsers Discussion Boards under the title of Addendum to previous post about False bobbin breaks, etc. This thread is located at http://www.amayausers.com/discussion/showthread.php?5529-Addendum-to-previous-post-about-False-bobbin-breaks-etc Here is the message that has just been posted: *************** I just wanted to let everyone know that I am a newbie to machine embroidery; also new to these discussion boards. Today was a stressful day on the XT for me. The design I am stitching goes from a wide fill type font to a very thin/small font (same color all the way through) and I have had nothing but problems with it. Since I started stitching I have not had this many problems with any given design other than maybe my first project ever on the machine. Constant false bobbin breaks, constant needle unthreading and threadbreaks. I had some help earlier from a couple people (thank you!) and I did the things they recommended but the stitch would only run smooth for 2 or 3 shirts then bam it starts to happen again. The unthreading usually happens after a trim. Does anyone have any further advice or has anyone had a similar problem with False bobbin breaks? I changed bobbins, cases, needles, changed my needle angle (because it was overly angled). My previous post was titled somethi ng like Help with false bobbin breaks and needle unthreading earlier today, but I am still dumbfounded as to why I did all the things recommended earlier and it worked for 2-3 shirts then started again. I make a few adjustments again, then it starts again after 2. Over and Over! So any info for the new guy would be nice, thank you all. *************** =========================================================== The AmayaUsers Mailing List Website: http://www.amayausers.com Discussion Board: http://www.amayausers.com/boards Subscribe/Unsubscribe: http://www.amayausers.com/list ===========================================================