[amayausers.com] New Post/Thread Notification: Embroidery / How Do I?
- From: "AmayaUsers Discussion Boards" <theboards@xxxxxxxxxxxxxx>
- To: amayausers@xxxxxxxxxxxxx
- Date: Thu, 06 Mar 2014 15:48:51 +0000
Hello,
mikeiarocci22 has just posted in the Embroidery / How Do I? forum of AmayaUsers
Discussion Boards under the title of 3d puffy foam questions.
This thread is located at
http://www.amayausers.com/discussion/showthread.php?5731-3d-puffy-foam-questions
Here is the message that has just been posted:
***************
hello all, I have a small story to tell with a few questions afterwards.
here at our shop we have been working with 3d puff for a few months now and we
cannot seem to get it right. We had an offer to do a job on flex fit hats it is
a relatively simple design, just 3 large letters in puff on top of a flat
fill/outline. we have adjusted all the settings in the operating system and
also had the design digitized twice so we know it is us now and not the
digitizing that is the problem. Does anyone have a recommendation for what has
absolutely worked best for them as far as settings. what were the upper and
lower limits you used? what was the presser foot setting? What was the backing
used? What needle and anything else that might apply to help us out?
We really want to offer 3d puff designs to our customers because not many
people in our area do it in house if any at all.
Thanks all for your time,
***************
===========================================================
The AmayaUsers Mailing List
Website: http://www.amayausers.com
Discussion Board: http://www.amayausers.com/boards
Subscribe/Unsubscribe: http://www.amayausers.com/list
===========================================================
Other related posts:
