Hello,
Mama Kass has just posted in the Embroidery / How Do I? forum of AmayaUsers
Discussion Boards under the title of Hoop Tech vs. Melco Setup.
This thread is located at
http://www.amayausers.com/discussion/showthread.php/6890-Hoop-Tech-vs-Melco-Setup
Here is the message that has just been posted:
***************
I think that using a cap driver that did not come set up for your machine is
more complicated than just attaching it to the machine. I had a wide-angle cap
driver that I was willing to practically give away in 2010; nobody wanted it,
so I eventually threw it away. I remember that in order to find out about
compatibility, the machine serial number was required. I also remember that
some type of calibration was also required if the driver did not come with the
machine. Here is a link to a thread where we talked about compatibility:
http://www.amayausers.com/discussion/showthread.php/6410-wide-angle-cap-driver-for-Big-Red?highlight=cap+driver+big+red
This link is to the Amaya Operator's Manual's. You can navigate from this page
to "Installing or Removing the Wide Angle Cap Driver" or "Adjusting the Wide
Angle Cap driver."
http://www.melco-service.com/docs/AMAYA_OS_v10/AmayaOperator.htm
***************
===========================================================
The AmayaUsers Mailing List
Website: http://www.amayausers.com
Discussion Board: http://www.amayausers.com/boards
Subscribe/Unsubscribe: http://www.amayausers.com/list
===========================================================