Hello,
samme has just posted in the Embroidery / How Do I? forum of AmayaUsers
Discussion Boards under the title of 3D foam Otto hats.
This thread is located at
http://www.amayausers.com/discussion/showthread.php?6396-3D-foam-Otto-hats
Here is the message that has just been posted:
***************
On 3D foam I've had some luck with turning off all bobbin sensor, set manual
actifeed at 22. Presser foot 5 or 6 clicks up from bottom, lower speed to 750.
I didn't mess with run/fill. A company say they digitized for the foam but it
was really just regular digitizing. I've found a good digitizer if all this
doesn't work let me know and I'll give you the contact info!!
***************
===========================================================
The AmayaUsers Mailing List
Website: http://www.amayausers.com
Discussion Board: http://www.amayausers.com/boards
Subscribe/Unsubscribe: http://www.amayausers.com/list
===========================================================