[amayausers.com] Re: How to re-install big thumb screws for cap assembly?
- From: theboards@xxxxxxxxxxxxxx
- To: amayausers@xxxxxxxxxxxxx
- Date: Fri, 20 Nov 2009 13:44:42 UT
This message was posted by Rod or Sharon on AmayaUsers.com. PLEASE DO NOT REPLY
VIA EMAIL. Instead, respond to the thread on the WEBSITE by clicking here:
http://www.amayausers.com/boards/ultimatebb.php?/topic/1/824.html#000002
Loyda,
Assuming that you have the two piece XT Cap Driver, the one where the two bars
can stay attached under the sewing arm or be removed if they are to get in the
way of doing special projects....
Detach the bar assembly from the sewing arm. On the top side of the platform
you will see 4 screws that hold it to the vertical supports. The eaisest way I
have found to explain this process, is to instruct the person to remove 3 of
these screws, loosen the 4th one, swing the top platform slightly to the side
enough to get the screw in and then re-assemble the bar assembly....
Rod Springer
Amaya Tech & Trainer
===========================================================
The AmayaUsers Mailing List
Website: http://www.amayausers.com
Discussion Board: http://www.amayausers.com/boards
Subscribe/Unsubscribe: http://www.amayausers.com/list
===========================================================
Other related posts:
