This message was posted by Marcelle on AmayaUsers.com. PLEASE DO NOT REPLY VIA EMAIL. Instead, respond to the thread on the WEBSITE by clicking here: http://www.amayausers.com/boards/cgi-bin/ultimatebb.cgi?/topic/2/1217.html#000003 There is not a color change at the bottom, I checked that first because it has happened before. The only way I found the problem was going down the entire stitches list until I found the problem after stitch # 12,336. These odd looking color changes can be seen at the first photo link in my original post. I did get around it by defining all 3 colors in OS as Gold, Green, Green which then makes the extra color match the 2nd color which will be skipped because of where these two color changes are located. What I am hoping to find out is how to delete that extra color change. It does not show up in the project tree and I can't delete it from the stitches view. The two color changes being right together actually cause OS to just skip the 2nd color and go to the 3rd color because there are no stitches between the color changes. If I only define 2 colors in OS it goes back to color # 1 to stitch the part that should be green because I did not define color #3. I did not use black in the design at all but black shows up in OS. I have occasionally had odd color sequences when stitching out designs before using V9. I thought I just did my colors wrong. I think I did not realize what was happening and that I had one (or more) extra color changes in the design because the designs all had a lot of colors. I am now checking more closely because I can't depend on what shows up in OS to be the same as what I just viewed in DS. Thanks for all the suggestions but I already tried all of them before I posted my question. =========================================================== The AmayaUsers Mailing List Website: http://www.amayausers.com Discussion Board: http://www.amayausers.com/boards Subscribe/Unsubscribe: http://www.amayausers.com/list ===========================================================