[THIN] Re: Cannot Print on newly built XenApp 6.5 Server
- From: Joe Shonk <joe.shonk@xxxxxxxxx>
- To: "thin@xxxxxxxxxxxxx" <thin@xxxxxxxxxxxxx>
- Date: Sun, 27 Oct 2013 21:57:48 -0600
Just uninstall XenApp and reinstall. Make sure IESEC policies are turned
and re-enable any services that you may have disabled. Print Spooler,
Firewall, etc.
Joe
On Sun, Oct 27, 2013 at 5:51 PM, Angela Smith <angela_smith9@xxxxxxxxxxx>wrote:
> Hi
>
> Unfortunately this didn't work. Also did a xenapp repair. .Any other
> suggestions?
>
> Thanks
> Ang
>
> ------------------------------
> Date: Fri, 25 Oct 2013 17:03:03 -0500
> Subject: [THIN] Re: Cannot Print on newly built XenApp 6.5 Server
> From: gareese@xxxxxxxxx
> To: thin@xxxxxxxxxxxxx
>
>
> http://support.citrix.com/article/CTX106683
>
>
>
>
> On Fri, Oct 25, 2013 at 4:56 PM, Angela Smith
> <angela_smith9@xxxxxxxxxxx>wrote:
>
> Hi
>
> I have an issue where I just built a refresh Windows 2008 R2/XenApp 6.5
> server. The Print Spooler was disabled during the Citrix install (by
> accident). The Print Spooler was later changed to Automatic and it starts
> OK. Citrix is installed but Printing doesn’t work. I get the following
>
> Event 1116
> Printer auto-creation failure. Reason: AddPrinter() failed with status
> 0x5. Client name: (xxxxxx) Printer name: (xxxxxx) in session 4) Port name:
> (xxxxxx) Driver name: (Citrix Universal Printer) Print processor: (Citrix
> Print Processor)
>
> I'm assuming I need to recreate the Printing Subsystem on XenApp 6.5 due
> to the Print Spooler being disabled on initial install? Would this be the
> case? If so how can I do it?
>
> Thanks
> Ang
>
>
>
Other related posts:
