Check for proper regulated B+ (130V ?) on the horizontal outputs collector. Scope the waveform as the sets starts and verify a nice clean 1200V pulse. Any ringing or distortion = bad flyback ========================== Jeff Stielau Shoreline Electronics Repair 344 East Main Street Clinton,CT 06413 860-399-1861 860-664-3535 (fax) jstielau@xxxxxxxx ======================== "If you push something hard enough it will fall over." Fudd's First Law of Opposition - Sir Sidney Fudd ----- Original Message ----- From: "Alvin Rose" <ajroseca@xxxxxxxxxxxxxxx> To: <techassist@xxxxxxxxxxxxx> Sent: Sunday, August 08, 2004 1:34 AM Subject: [TechAssist] Zenith model A25A12D CHASSIS GA-2 Warrior line > We have a zenith Model a25a12d chassis GA-2 which is shuting down > changed cx3431 22 mfd 63 volt electrolytic and cx3268 22mfd@160v > no change..Unsoldered vertical IC but still shuts down..Unit will only run > for several seconds..any help on this one would be appreciated > Alvin Rose > Radio & tv Centre > Marystown, Nl > > > > -------------------------------------------------------------------------- --- > Lost Password: > http://www.tech-assist.org and select "Login Problems?". > Email Archives: > //www.freelists.org/archives/techassist/ > ----------------------------------------------------------------------------- Lost Password: http://www.tech-assist.org and select "Login Problems?". Email Archives: //www.freelists.org/archives/techassist/