Shaun, On the stand-up PCB in the center of the 1674, you need to remove the support bracket and solder the connections for the plug that go to the CRT boards. Jeff -- Intrepid Video TV/VCR Repair 263 S Front St, Steelton PA 17113 717-939-7708; (F) 717-564-4952 www.intrepid-video.com www.tech-repair.net ----- Original Message ----- From: "Shaun" <satguy@xxxxxxxxxxxxx> To: "tech" <techassist@xxxxxxxxxxxxx> Sent: Monday, November 01, 2004 7:33 PM Subject: [TechAssist] Zenith PVY5264DT (9-1674-3) SMPS No filaments lighting This set came in dead I replaced the Flyback, horz output and CR3412 all were shorted. The set fires up now and has high voltage and sound, but no raster. The filaments are not lighting up, I checked the high voltage block and it measures 47k. I checked the board for cold solder, loose connections and burned resistors everything looks and measures good. Does anyone have any idea what I am missing on this one? Shaun Advanced Electronics 224 West Riverview Ave. Fort Morgan, CO 80701 ----------------------------------------------------------------------------- Lost Password: http://www.tech-assist.org and select "Login Problems?". Email Archives: //www.freelists.org/archives/techassist/ ----------------------------------------------------------------------------- Lost Password: http://www.tech-assist.org and select "Login Problems?". Email Archives: //www.freelists.org/archives/techassist/