Shaun, Be sure you solder the connector on the daughter board, that goes to the CRT's PCBs. Jeff -- Intrepid Video TV/VCR Repair 263 S Front St, Steelton PA 17113 717-939-7708; (F) 717-564-4952 www.intrepid-video.com www.tech-repair.net ----- Original Message ----- From: "Shaun" <satguy@xxxxxxxxxxxxx> To: "tech" <techassist@xxxxxxxxxxxxx> Sent: Friday, August 20, 2004 12:27 PM Subject: [TechAssist] Zenith A60M91W1 Problems This 60 inch Zenith tv was dead. I installed a kit from Tritronics to repair the 9-1978-1 module. When I reinstalled the board the set does turn on now but the convergence is not working at all and the picture that does come up goes brighter and darker in a pulsing way. Does anyone have any tips on this problem? I checked the convergence module all the resistors are good. The set is 40 miles away from the shop and I do not know if the +16 and -16 are there but I would like to try and find any other problems on the 9-1978-1 first. I also found RX3206 and R3252 open near the flyback. Shaun Advanced Electronics 224 West Riverview Ave. Fort Morgan, CO 80701 ----------------------------------------------------------------------------- Lost Password: http://www.tech-assist.org and select "Login Problems?". Email Archives: //www.freelists.org/archives/techassist/ ----------------------------------------------------------------------------- Lost Password: http://www.tech-assist.org and select "Login Problems?". Email Archives: //www.freelists.org/archives/techassist/