[TechAssist] Re: Zen Projo PVR4663RK C-8 SM # PV147 Convergence problem

  • From: "Lyles Tv" <tech@xxxxxxxxxxx>
  • To: <techassist@xxxxxxxxxxxxx>
  • Date: Thu, 25 Jul 2002 09:04:59 -0500


I'm sorry,  I needed a comma there.  The 26vdc is dead on.  The red moves
normally, the blue moves up and down normally, it just won't move to the
right far enough.  I would normally suspect a non-tech going in mis
adjusting something, but I know for a fact that this a virgin.  I replaced
all 3 stks' now, and no change. TIA

Jeff Farnsworth
Lyles TV and Appliance
17 S Washington St
Elkhorn, Wi.  53121
ph    262-723-3477
fax   262-723-3658
tech@xxxxxxxxxxx
----- Original Message -----
From: "Satguy" <satguy@xxxxxxxxxxxxx>
To: <techassist@xxxxxxxxxxxxx>
Sent: Thursday, July 25, 2002 12:26 AM
Subject: [TechAssist] Re: Zen Projo PVR4663RK C-8 SM # PV147 Convergence
problem


> If the convergence module is bad one thing to check is the glass fuses on
> the new smps module make sure none are open. Second does the red move at
> all? If all is good with the red then your problem is with the resistors
or
> the ic for the blue, but it's probably a combination of things. When you
say
> + - 26 volts dead is that coming from the smps?
>
> Shaun
> Advanced Electronics
> Fort Morgan, CO 80701
> (970) 867-3124
> satguy@xxxxxxxxxxxxx
> ----- Original Message -----
> From: "Lyles Tv" <tech@xxxxxxxxxxx>
> To: <techassist@xxxxxxxxxxxxx>
> Sent: Wednesday, July 24, 2002 3:14 PM
> Subject: [TechAssist] Zen Projo PVR4663RK C-8 SM # PV147 Convergence
problem
>
>
> > Zen Projo PVR4663RK C-8 SM # PV147 Convergence problem
> >
> > The blue will not converge far enough to the right.
> >
> > Originally had bad fly, so I replaced the smps module. I checked
> everything on the 9-1318-02 convergence module as well as possible, and
> then I replaced the blue STK, and it still won't move far enough over.
> 26vdc is dead on both + and -  Zenith schematic is worthless for
waveforms.
> I remember calling zenith about one of these convergence modules once, and
> he didn't know much other than--"replace the module"  Help is appreciated.
> TIA
> >
> > Jeff Farnsworth
> > Lyles TV and Appliance
> > 17 S Washington St
> > Elkhorn, Wi.  53121
> > ph    262-723-3477
> > fax   262-723-3658
> > tech@xxxxxxxxxxx
> >
> > ------------------------------------------
> > To REMOVE your email address, click here:
> >   http://www.tech-assist.org/unsubb.html
> > To CHANGE your email address, click here:
> >   http://www.tech-assist.org/change.html
> > ------------------------------------------
> > ***NEW*** Tips Added Instantly!!!***
> > Submit Repair Tips here:
> > http://www.tech-assist.org/secure/tip/
>
>
> ------------------------------------------
> To REMOVE your email address, click here:
>   http://www.tech-assist.org/unsubb.html
> To CHANGE your email address, click here:
>   http://www.tech-assist.org/change.html
> ------------------------------------------
> ***NEW*** Tips Added Instantly!!!***
> Submit Repair Tips here:
> http://www.tech-assist.org/secure/tip/
>

------------------------------------------
To REMOVE your email address, click here:
  http://www.tech-assist.org/unsubb.html
To CHANGE your email address, click here:
  http://www.tech-assist.org/change.html
------------------------------------------
***NEW*** Tips Added Instantly!!!***
Submit Repair Tips here: 
http://www.tech-assist.org/secure/tip/

Other related posts: