If you don't have the +26 and the -26v,then the problem is comming off the smps module unless the conv.bd has a short,loading dn this supplies.Verify that the conv.bd is not causing the problem. Mando Birdie's TV & Electronics Casa Grande,AZ birdie@xxxxxxxxxxxxx Lyles Tv wrote: > Zen Projo PVR4663RK C-8 SM # PV147 Convergence problem > > The blue will not converge far enough to the right. > > Originally had bad fly, so I replaced the smps module. I checked everything > on the 9-1318-02 convergence module as well as possible, and then I replaced > the blue STK, and it still won't move far enough over. 26vdc is dead on both > + and - Zenith schematic is worthless for waveforms. I remember calling > zenith about one of these convergence modules once, and he didn't know much > other than--"replace the module" Help is appreciated. TIA > > Jeff Farnsworth > Lyles TV and Appliance > 17 S Washington St > Elkhorn, Wi. 53121 > ph 262-723-3477 > fax 262-723-3658 > tech@xxxxxxxxxxx > > ------------------------------------------ > To REMOVE your email address, click here: > http://www.tech-assist.org/unsubb.html > To CHANGE your email address, click here: > http://www.tech-assist.org/change.html > ------------------------------------------ > ***NEW*** Tips Added Instantly!!!*** > Submit Repair Tips here: > http://www.tech-assist.org/secure/tip/ ------------------------------------------ To REMOVE your email address, click here: http://www.tech-assist.org/unsubb.html To CHANGE your email address, click here: http://www.tech-assist.org/change.html ------------------------------------------ ***NEW*** Tips Added Instantly!!!*** Submit Repair Tips here: http://www.tech-assist.org/secure/tip/