I don't know if this will help, but pin 13 looks like a ripple filter for the circuit, and I doubt it's hooked to the vert output...... http://www.nteinc.com/specs/7000to7099/pdf/nte7085.pdf that's what it crosses to.... Damon Brunger Telrad Electronic Services Ft Wayne, IN 46815 ----- Original Message ----- From: "Bruce Tiedeman" <btied@xxxxxxxxxxxx> To: <techassist@xxxxxxxxxxxxx> Sent: Thursday, August 05, 2004 12:03 PM Subject: [TechAssist] Mitsubishi CS2657 (TM3-A-C57R) Print? | Looking for a print of the Vertical section in this set. It uses LA7836 | output. The traces are damaged and I need to confirm hook up. In question is | Pin 13, looks like it might hook up to pin 11 but am not sure. Also there is | a zener diode I suspect is bad, Location D410 (5DO9). The anode goes to pin | 4 and Cathode to pin 1. There is only 1.5 volts on pin 1. | thanks for any help, | Bruce. | | B&T Electronics | 139 Margaret St | Sarnia Ontario | Canada | N7T 2Y3 | 519 344 1850 | | | | -------------------------------------------------------------------------- --- | Lost Password: | http://www.tech-assist.org and select "Login Problems?". | Email Archives: | //www.freelists.org/archives/techassist/ | ----------------------------------------------------------------------------- Lost Password: http://www.tech-assist.org and select "Login Problems?". Email Archives: //www.freelists.org/archives/techassist/