[TechAssist] Re: LXI M#564.54710751 (Toshiba) mfg. 3/88, video driver prob.

  • From: "teltek2" <teltek2@xxxxxxxxxxxx>
  • To: <techassist@xxxxxxxxxxxxx>
  • Date: Mon, 9 Dec 2002 13:16:23 -0500

Daryl;
Just tell your customers...Sears doesn't have "same day service" either.
Maybe better at this time to give it back to him, and try Sears, then he
will find out.

-Ed-

Tel-Tek Electronics
Ontario-Canada

teltek2@xxxxxxxxxxxx
----- Original Message -----
From: "D Thunhurst" <dthunhurst@xxxxxxx>
To: <techassist@xxxxxxxxxxxxx>
Sent: Monday, December 09, 2002 12:41 PM
Subject: [TechAssist] Re: LXI M#564.54710751 (Toshiba) mfg. 3/88, video
driver prob.


>
> I stand corrected.
> That's what happens when you ASS_U_ME instead of confirming.  The set has
a
> Toshiba labeled crt and tuner along with several IC's.  Also the customer
> told me it was a 35" but I think it is actually a 32" set.
> I have taken the advice of several and soldered the connectors to the crt
> board even if they looked alright but no help.
> I have made a bit of progress on this.  I can get a picture with the rgb
> driver collectors running at 146 volts by adjusting what appears to be a
> brightness range control.  However, with scene changes it flares out of
> brightness stability.  I am leaning towards the ABL circuit.  There also
is
> no changes in the picture when I vary the brightness or contrast but OSD
> indicates changes.  It appears that possibly it is all controlled by the
> jungle chip.
> Without the literature, I am guessing.  I would replace the chip but no
one
> locally has it and of course the customer is expecting to have his set
back
> today.
> Thanks,
> Daryl
> Daryl's TV
> 3310 Dyer St.
> El Paso, TX 79930
> 915-565-9184
> 915-564-1024 Fax
> http://dynacomp.freeyellow.com
> -----Original Message-----
> From: gulftech@xxxxxxxx <gulftech@xxxxxxxx>
> To: techassist@xxxxxxxxxxxxx <techassist@xxxxxxxxxxxxx>
> Date: Monday, December 09, 2002 9:00 AM
> Subject: [TechAssist] Re: LXI M#564.54710751 (Toshiba) mfg. 3/88, video
> driver prob.
>
>
> >
> >Daryl,
> >
> >564 is Sanyo/Fisher, not Toshiba.  Resolder the wires from/to the crt
> >pcb.  May look good, but resolder them anyway.
> >
> >
> >Ken Smith
> >Gulf Technical Services
> >3034 Gulf Breeze Parkway
> >Gulf Breeze, FL  32563
> >850-934-8324 (Voice) 850-932-0819 (Fax)
> >
> >
> >On Mon, 9 Dec 2002 07:36:04 -0700 "D Thunhurst" <dthunhurst@xxxxxxx>
> >writes:
> >>
> >> Hi,
> >> I have an old sears 35", 564.54710751 made by Toshiba.
> >> No chassis number found and I have not been able to cross to any
> >> Toshiba
> >> numbers.  Sams is available only by photocopy.
> >> Set came in with intermittent vert. deflection.  Found the usual bad
> >> solder
> >> joints throughout the chassis.  Esr'd the electros and didn't find
> >> anything
> >> else bad.  Traced my footsteps for possible solder bridges,
> >> connectors in
> >> the wrong place, etc. (none found).
> >> Problem now is I have full deflection but have washed out video.  The
> >> picture looks like the usual symptom you get on the Zeniths that
> >> have the
> >> transistor shorted on the crt board.
> >> I'm not sure if it is a ABL problem or a video driver problem.  I
> >> have 36
> >> volts on the RGB collectors but can bias the transistors to turn off
> >> and
> >> give me my 200 volts.  However, when I turn up G2, I get a pulsing
> >> on the
> >> screen and momentarily get good video while it is pulsing ( pulses
> >> at rate
> >> of about one second).  The RGB collectors then pulse from 36 to 145
> >> volts.
> >> If anyone has any ideas or has a cure or possibly run a scan of the
> >> video
> >> driver and ABL circuits.
> >> Thanks,
> >> Daryl
> >> Daryl's TV
> >> 3310 Dyer St.
> >> El Paso, TX 79930
> >> 915-565-9184
> >> 915-564-1024 Fax
> >> http://dynacomp.freeyellow.com
> >>
> >> ------------------------------------------
> >> Submit A Repair Tip For Everyone Here:
> >> http://www.tech-assist.org/secure/tip/main.html
> >> ------------------------------------------
> >> To REMOVE your email address, click here:
> >>   http://www.tech-assist.org/unsubb.html
> >> To CHANGE your email address, click here:
> >>   http://www.techassist.net/forms/change.html
> >>
> >>
> >
> >
> >________________________________________________________________
> >Sign Up for Juno Platinum Internet Access Today
> >Only $9.95 per month!
> >Visit www.juno.com
> >------------------------------------------
> >Submit A Repair Tip For Everyone Here:
> >http://www.tech-assist.org/secure/tip/main.html
> >------------------------------------------
> >To REMOVE your email address, click here:
> >  http://www.tech-assist.org/unsubb.html
> >To CHANGE your email address, click here:
> >  http://www.techassist.net/forms/change.html
> >
> >
>
> ------------------------------------------
> Submit A Repair Tip For Everyone Here:
> http://www.tech-assist.org/secure/tip/main.html
> ------------------------------------------
> To REMOVE your email address, click here:
>   http://www.tech-assist.org/unsubb.html
> To CHANGE your email address, click here:
>   http://www.techassist.net/forms/change.html
>

------------------------------------------
Submit A Repair Tip For Everyone Here:
http://www.tech-assist.org/secure/tip/main.html
------------------------------------------
To REMOVE your email address, click here:
  http://www.tech-assist.org/unsubb.html
To CHANGE your email address, click here:
  http://www.techassist.net/forms/change.html

Other related posts: