call 1-800-851-8885, the main line.Verify what the tech assist number is. Dunn Ron wrote: > > Can't help on M#'s. sounds as though customer has tried to remove jammed > cassette. check either tray loading gears or tape loading motor area > (capstan drive) for misalignment or stripped teeth. hope these help. good > luck > > >From: Demers_Steve@xxxxxxx > >Reply-To: techassist@xxxxxxxxxxxxx > >To: techassist@xxxxxxxxxxxxx > >Subject: [TechAssist] Frustrated Tech --- Philips Magnavox TV/VCR Combo > >Date: Fri, 30 Nov 2001 07:35:57 -0500 > > > > > >Well..Were should I start.... > > > >I still haven't found out a model # for the TV/VCR combo unit.... I've just > >about called every person on earth and one knows anything > >Tried to use Philips's 900 (900-896-8324) number but didn't get anything... > >I guess that number is not in service.?.?.? Go figure..! > >So I gambled and replaced both IR LED's and the center LED. Also I cleaned > >the mode switch. > > > >Result = Same problem as before > > > >Symtoms = Attempts to eject tape automatically then 10 seconds later.... > >Good bye.. > > > >TV screen message = Stop then C or T Eject > > > >The only way I can prevent it from shutting off is by shining a light into > >the start sensor(At least I think its start sensor) > > > >I have voltage readings at both sensors (Above 4.6 v) > > > >I've just about had it with this unit....! > > > >**Here's some internal numbers** > > > >Monitor Make=FUNAI > >Model # A48KRD89X > >Serial # 803241687 > > > >Circuit Board # BB5900F01012 (Part #...?) > > > >VCR Chassis # MK7-F1(Part #...?) > > > > > >Please help...Any suggestion would be helpful. > > > >Steven > > > > > > > ----- Original Message ----- > > > From: <Demers_Steve@xxxxxxx> > > > To: <techassist@xxxxxxxxxxxxx> > > > Sent: Tuesday, November 20, 2001 7:23 AM > > > Subject: [TechAssist] Philips Magnavox TV/VCR Combo > > > > > > > > > > > > I'm looking for some information on a Philips Magnavox TV/VCR Combo > > > unit..... The only thing is... I don't have a model number. The model > > > number > > > sticker has been ripped off. > > > > > > I "think" this is the model number > > > Philips Magnavox CCA192AT 19" TV/VCR Combo > > > From whats left of the sticker off the back of the TV's Shell. It > >appears > > > the unit was manufactured in 1998. Is there anything else I can use to > >pin > > > point the model number of this unit..? For instance, model number/serial > > > off > > > the circuit board, etc. > > > > > > QUESTION: > > > The unit faults ever time its turned on.. It appears to be a sensor > > > problem > > > on the VCR.. At least I think... The VCR attempts too eject tape when > > > there > > > no tape installed. Then approx. 10 mins later the unit faults and shuts > > > off... Any suggestions on what I can check right away? > > > Thanks, > > > Steven Demers > > > ================================= > > > Help make your TechAssist database better! > > > Submit your fixes here: http://circuitwork.com/techassist/tip/#tips > > > ================================= > > > To UNSUBSCRIBE your email address, click here: > > > mailto:techassist-request@xxxxxxxxxxxxx?subject=unsubscribe > > > > > > > >================================= > >Help make your TechAssist database better! > >Submit your fixes here: http://circuitwork.com/techassist/tip/#tips > >================================= > >To UNSUBSCRIBE your email address, click here: > >mailto:techassist-request@xxxxxxxxxxxxx?subject=unsubscribe > > > > _________________________________________________________________ > Get your FREE download of MSN Explorer at http://explorer.msn.com/intl.asp > > ================================= > Help make your TechAssist database better! > Submit your fixes here: http://circuitwork.com/techassist/tip/#tips > ================================= > To UNSUBSCRIBE your email address, click here: > mailto:techassist-request@xxxxxxxxxxxxx?subject=unsubscribe ================================= Help make your TechAssist database better! Submit your fixes here: http://circuitwork.com/techassist/tip/#tips ================================= To UNSUBSCRIBE your email address, click here: mailto:techassist-request@xxxxxxxxxxxxx?subject=unsubscribe