[TechAssist] Re: Frustrated Tech --- Philips Magnavox TV/VCR Combo
- From: "Dunn Ron" <showmeron@xxxxxxxxxxx>
- To: techassist@xxxxxxxxxxxxx
- Date: Fri, 30 Nov 2001 08:08:43 -0600
Can't help on M#'s. sounds as though customer has tried to remove jammed
cassette. check either tray loading gears or tape loading motor area
(capstan drive) for misalignment or stripped teeth. hope these help. good
luck
>From: Demers_Steve@xxxxxxx
>Reply-To: techassist@xxxxxxxxxxxxx
>To: techassist@xxxxxxxxxxxxx
>Subject: [TechAssist] Frustrated Tech --- Philips Magnavox TV/VCR Combo
>Date: Fri, 30 Nov 2001 07:35:57 -0500
>
>
>Well..Were should I start....
>
>I still haven't found out a model # for the TV/VCR combo unit.... I've just
>about called every person on earth and one knows anything
>Tried to use Philips's 900 (900-896-8324) number but didn't get anything...
>I guess that number is not in service.?.?.? Go figure..!
>So I gambled and replaced both IR LED's and the center LED. Also I cleaned
>the mode switch.
>
>Result = Same problem as before
>
>Symtoms = Attempts to eject tape automatically then 10 seconds later....
>Good bye..
>
>TV screen message = Stop then C or T Eject
>
>The only way I can prevent it from shutting off is by shining a light into
>the start sensor(At least I think its start sensor)
>
>I have voltage readings at both sensors (Above 4.6 v)
>
>I've just about had it with this unit....!
>
>**Here's some internal numbers**
>
>Monitor Make=FUNAI
>Model # A48KRD89X
>Serial # 803241687
>
>Circuit Board # BB5900F01012 (Part #...?)
>
>VCR Chassis # MK7-F1(Part #...?)
>
>
>Please help...Any suggestion would be helpful.
>
>Steven
>
>
> > ----- Original Message -----
> > From: <Demers_Steve@xxxxxxx>
> > To: <techassist@xxxxxxxxxxxxx>
> > Sent: Tuesday, November 20, 2001 7:23 AM
> > Subject: [TechAssist] Philips Magnavox TV/VCR Combo
> >
> >
> >
> > I'm looking for some information on a Philips Magnavox TV/VCR Combo
> > unit..... The only thing is... I don't have a model number. The model
> > number
> > sticker has been ripped off.
> >
> > I "think" this is the model number
> > Philips Magnavox CCA192AT 19" TV/VCR Combo
> > From whats left of the sticker off the back of the TV's Shell. It
>appears
> > the unit was manufactured in 1998. Is there anything else I can use to
>pin
> > point the model number of this unit..? For instance, model number/serial
> > off
> > the circuit board, etc.
> >
> > QUESTION:
> > The unit faults ever time its turned on.. It appears to be a sensor
> > problem
> > on the VCR.. At least I think... The VCR attempts too eject tape when
> > there
> > no tape installed. Then approx. 10 mins later the unit faults and shuts
> > off... Any suggestions on what I can check right away?
> > Thanks,
> > Steven Demers
> > =================================
> > Help make your TechAssist database better!
> > Submit your fixes here: http://circuitwork.com/techassist/tip/#tips
> > =================================
> > To UNSUBSCRIBE your email address, click here:
> > mailto:techassist-request@xxxxxxxxxxxxx?subject=unsubscribe
> >
> >
>=================================
>Help make your TechAssist database better!
>Submit your fixes here: http://circuitwork.com/techassist/tip/#tips
>=================================
>To UNSUBSCRIBE your email address, click here:
>mailto:techassist-request@xxxxxxxxxxxxx?subject=unsubscribe
>
_________________________________________________________________
Get your FREE download of MSN Explorer at http://explorer.msn.com/intl.asp
=================================
Help make your TechAssist database better!
Submit your fixes here: http://circuitwork.com/techassist/tip/#tips
=================================
To UNSUBSCRIBE your email address, click here:
mailto:techassist-request@xxxxxxxxxxxxx?subject=unsubscribe
Other related posts:
