Have you put Speed Bleeders on Murray??? I have been looking for this info for a very long time. I didn't think that Speed Bleeder made the correct metric size to use on Split Buses? Can you verify Denis? Denis Dodson said: > I had a bleeder that would not come off. I had to bleed the brakes at the > line. I used 7mm wrenches, vice grips, PB, MAPP torch, everything and I > was > sure that I was going to shear the bleeder and then, it struck me! I > replaced the friggin' brake cylinder. It was a bargain after all the man > hours I had wasted trying to get the bleeder open. > > Replace the cylinder and put on speed bleeders, available almost > everywhere > or on the internet > > > > ----- Original Message ----- > From: "Eric Woodall" <eric@xxxxxxxxxxxxxx> > To: <tcb@xxxxxxxxxxxxx> > Sent: Friday, July 06, 2007 10:37 AM > Subject: [tcb] Re: Bleeding Brakes (nipple size?) > > > Trey, bust out the blow torch [with map gas]. > It'll come off. > > vw1971 said: >> I'm trying to adjust the rear brakes and I wanted to take a look at the >> shoes and brake cylinders first but I've been whacking at the 46mm nut >> with >> no luck for the last 30 minutes....I wonder if I could apply some PB >> Blaster >> on the nut to help loosen it.... >> >> I got the vice grips ....... >> >> >> >> On 7/6/07, sammie smith <bugcollections@xxxxxxxxxxxxx> wrote: >>> >>> I thought the same thing. I didn't even know he was on the list. Just >>> takes an interesting subject I guess to bring him out in the open, >>> >>> *Will <evilscientistboo@xxxxxxxxxxxxx>* wrote: >>> >>> Larry? Where have you been? >>> >>> >>> ------------------------------ >>> From: lparrottvw@xxxxxxxx <lparrottvw@xxxxxxxx> >>> Sent: Friday, July 06, 2007 5:44 AM >>> To: tcb@xxxxxxxxxxxxx >>> Cc: tcb@xxxxxxxxxxxxx >>> Subject: [tcb] Re: Bleeding Brakes (nipple size?) >>> >>> 42 D's >>> >>> >>> >> > > > > > > -- > No virus found in this incoming message. > Checked by AVG Free Edition. > Version: 7.5.476 / Virus Database: 269.10.1/888 - Release Date: 7/6/2007 > 6:36 AM > > > >