[studiorecorder] Re: can't make the clip indicator beep
- From: "diverson" <diverson@xxxxxxxxx>
- To: <studiorecorder@xxxxxxxxxxxxx>
- Date: Mon, 27 Oct 2014 19:39:34 -0500
Problem solved.
Thank you very much Rob.
Now to find cords that don't give me a 60-cycle hum.
From: studiorecorder-bounce@xxxxxxxxxxxxx
[mailto:studiorecorder-bounce@xxxxxxxxxxxxx] On Behalf Of Rob Meredith
Sent: Monday, October 27, 2014 7:55 AM
To: studiorecorder@xxxxxxxxxxxxx
Subject: [studiorecorder] Re: can't make the clip indicator beep
Hi Duane,
With many sound cards, especially cheaper ones, a full-scale signal cannot
be achieved. Try going to Settings, Advanced Tab, Clip Indicator Settings
and changing to Clip Threshold value to something like -0.5. (You will
probably have to play with this value a bit. One way to determine what the
value should be is to record something loud where clipping is obvious and
note the peak level on the meter by pressing the letter "a." Set the
threshold a bit below this value.
Rob
From: studiorecorder-bounce@xxxxxxxxxxxxx
<mailto:studiorecorder-bounce@xxxxxxxxxxxxx>
[mailto:studiorecorder-bounce@xxxxxxxxxxxxx] On Behalf Of diverson
Sent: Saturday, October 25, 2014 4:24 PM
To: studiorecorder@xxxxxxxxxxxxx <mailto:studiorecorder@xxxxxxxxxxxxx>
Subject: [studiorecorder] can't make the clip indicator beep
I have done a lot of recording using Studio Recorder in the past but not a
lot lately: So I expected to be rusty.
I haven't touched SR since last spring and that was a whole computer ago.
Since then I bought a new computer with Windows 8.1, contact APH and
installed SR and more-or-less forgot about it.
Now after a pleasant wrangle with my Realtec sound card I got SR to record.
Great!
Unfortunately my clip indicator won't beep. Naturally I looked it up in the
manual.
I went through the settings and nothing worked. I can turn the volume up so
high the sound card blocks it but I can't make SR beep when I am setting my
source volume too high.
I looked through the rest of the settings thinking there was some peak meter
setting I had to change, I did not uncheck peak meter which was checked by
default but I did hit reset peak meter.
I had changed it to Time View so I changed it back to wave view and nothing
works.
Can someone tell me how to make the clip indicator beep?
Thank you.
Sincerely Yours;:
Duane Iverson
Other related posts:
