hello all: When test the ripple of the power of a board ,It's said that I should test it below 20MHz.But I found that it's much defferent when I test the ripple in the full band width frequency.As I think we should test the ripple without any frequency limit ,or we can't observe the noise produced by other devices which can couple into the power system .I hope someone will give me some !advice,thanks ------------------------------------------------------------------ To unsubscribe from si-list: si-list-request@xxxxxxxxxxxxx with 'unsubscribe' in the Subject field or to administer your membership from a web page, go to: //www.freelists.org/webpage/si-list For help: si-list-request@xxxxxxxxxxxxx with 'help' in the Subject field List technical documents are available at: http://www.si-list.net List archives are viewable at: //www.freelists.org/archives/si-list or at our remote archives: http://groups.yahoo.com/group/si-list/messages Old (prior to June 6, 2001) list archives are viewable at: http://www.qsl.net/wb6tpu