At 12:29 PM 4/15/2006 , Richard Knoppow wrote: > ... > I usually dry fiber prints on screens or by just hanging >them. I hang them using clothes pins at the corners with >additional pins on the bottom for weight. This seems to work >as well as any of he fancier methods. I think the key is to >dry the prints slowly enough to keep allow the support and >emulsion sides to maintain some degree of equilibrium. > April 16, 2006, from Lloyd Erlick, I hang my FB prints to dry regularly. Prints up to and including 11x14 need to be hung by one corner only. Prints 16x20 and 20x24 need to be hung by two top corners. The bottom corners need no clips or weights of any sort. Slow drying is essential. The more rapidly the sheets dry, the more likely they are to curl. More dry causes more curl. Humidity in the drying area is crucial, and must be monitored. Maintaining humidity in the human comfort range is important in the darkroom, and it is also easy and cheap to do. The comfort range is merely a fairly wide range of humidity that most people will experience as comfortable, or at least not uncomfortable. Let's call it 40% - 60% relative humidity. It is quite easy to keep a darkroom within those boundaries. High cost enters the picture if the range is narrowed. For example, a range of 49-51% would cost a lot to maintain. When prints are hanging to dry, it is best to have no air movement near the prints, so no heaters or humidifier or dehumidifier placed close to the hanging area. They can be placed at some distance if they are needed. If the moisture from the prints themselves raises humidity, just leave it be. It will not last long. regards, --le ________________________________ Lloyd Erlick Portraits, Toronto. voice: 416-686-0326 email: portrait@xxxxxxxxxxxx net: www.heylloyd.com ________________________________ -- ============================================================================================================= To unsubscribe from this list, go to www.freelists.org and logon to your account (the same e-mail address and password you set-up when you subscribed,) and unsubscribe from there.