Loctite 609 should hold it with no trouble. If the pulley face lines up with the end of the shaft you can always drill it for a scotch key as well as! On 18/04/2012 6:11 PM, Chris Crosskey wrote: > Does anyone have any recommendation for something that I can retain a pulley > on a shaft... it's a sliding fit at the moment and I need it to be able to > act as a drive for a rotavator.... are any of the loctite compounds suitable > for this? I'd rather avoid welding it on if at all possible.... currently my > lathe is out of action during its move from old workshop to the new one > otherwise I'd bore out the pulley and weld it to a sleeve that I could shrink > fit ontop the shaft... It'd be a bugger to key the shaft BTW, it's close to > the cases of the Honda engine it's part of and I don't want to strip the > motor .... > chrisc > > ________________________________________________________________________ > This e-mail, and any attachment, is confidential. If you have received it in > error, do not use or disclose the information in any way, notify me > immediately, and please delete it from your system. > ________________________________________________________________________ > MODEL ENGINEERING DISCUSSION LIST. > > To UNSUBSCRIBE from this list, send a blank email to, > modeleng-request@xxxxxxxxxxxxx with the word "unsubscribe" in the subject > line. > > MODEL ENGINEERING DISCUSSION LIST. To UNSUBSCRIBE from this list, send a blank email to, modeleng-request@xxxxxxxxxxxxx with the word "unsubscribe" in the subject line.