Does anyone have any recommendation for something that I can retain a pulley on a shaft... it's a sliding fit at the moment and I need it to be able to act as a drive for a rotavator.... are any of the loctite compounds suitable for this? I'd rather avoid welding it on if at all possible.... currently my lathe is out of action during its move from old workshop to the new one otherwise I'd bore out the pulley and weld it to a sleeve that I could shrink fit ontop the shaft... It'd be a bugger to key the shaft BTW, it's close to the cases of the Honda engine it's part of and I don't want to strip the motor .... chrisc ________________________________________________________________________ This e-mail, and any attachment, is confidential. If you have received it in error, do not use or disclose the information in any way, notify me immediately, and please delete it from your system. ________________________________________________________________________ MODEL ENGINEERING DISCUSSION LIST. To UNSUBSCRIBE from this list, send a blank email to, modeleng-request@xxxxxxxxxxxxx with the word "unsubscribe" in the subject line.