Hi Michael Talibard wrote: > I am not sure which list to send this to, Iyonix or Pilling Software, > and have opted for both: > > I installed ROM512 two or three days ago. This morning I tried to > use my scanner for the first time since then. It is an Epson 1660 > run by software from David Pilling. It now 'freezes' the machine > (if that is the right word). What happens is that, in DPling Scan, > I get as far as asking for a Preview or Scan, and everything stops. > Alt Break does nothing until I unplug the scanner, at which point > it invites me to 'Press Stop to terminate DPlingScan' and that > 'unfreezes' the machine. > th epson scanner is awkward to get going IF it is plugged in on computer startup. either use !USBKick to wake it up, or plug it in/or turn in its power after booting the iyonix. This is not a particularly new issue.. it would require a boot time of minutes to cleanly overcome this epson specific issue. > In trying to investigate this, I thought I'd Restore 511 and see if the > scanner would then work again. Tried this, got past the warning > about non-interruption, chose 'Full' rather than 'Transfer', but then > nothing seemed to happen. Now I'm not sure whether I have 511 or > 512 inplace, and don't know how to check. I THINK I'm still with 512, > so I had another go at Restore511. After the choice of Full it says > "Wrong programmer for your machine." > *fx0 will tell you. It is always possible that the restorer isn't behaving.. but, hey, you can get the 511 programmer by free download from http://www.iyonix.com/updates John > Advice, please. > --- > To alter your preferences or leave the group, > visit //www.freelists.org/list/iyonix-support > Other info via //www.freelists.org/webpage/iyonix-support > -- > This email has been verified as Virus free > Virus Protection and more available at http://www.plus.net > > --- To alter your preferences or leave the group, visit //www.freelists.org/list/iyonix-support Other info via //www.freelists.org/webpage/iyonix-support