In message <6724F5A2-89AA-4FE4-A328-846AF3809CC1@xxxxxxxxxxxx> Michael Talibard <michael@xxxxxxxxxxxx> wrote: > > I installed ROM512 two or three days ago. This morning I tried to > use my scanner for the first time since then. It is an Epson 1660 > run by software from David Pilling. It now 'freezes' the machine > (if that is the right word). What happens is that, in DPling Scan, > I get as far as asking for a Preview or Scan, and everything stops. > Alt Break does nothing until I unplug the scanner, at which point > it invites me to 'Press Stop to terminate DPlingScan' and that > 'unfreezes' the machine. > > In trying to investigate this, I thought I'd Restore 511 and see if the > scanner would then work again. Tried this, got past the warning > about non-interruption, chose 'Full' rather than 'Transfer', but then > nothing seemed to happen. Now I'm not sure whether I have 511 or > 512 inplace, and don't know how to check. I THINK I'm still with 512, > so I had another go at Restore511. After the choice of Full it says > "Wrong programmer for your machine." > > Advice, please. I had the same problem after installing 5.12 (maybe with a different Epson scanner). I restarted the Iyonix, ran !UsbInfo, and saw that it recognised the presence of the scanner. Ever since the scanner has worked fine. Mick Dunford --- To alter your preferences or leave the group, visit //www.freelists.org/list/iyonix-support Other info via //www.freelists.org/webpage/iyonix-support