You can select part, RMB then Edit Part Here you can edit pins names and numbers. Edited part stays in your Design Cache with its original name plus ...._0 etc. Regards, Shahed -----Original Message----- From: icu-pcb-forum-bounce@xxxxxxxxxxxxx [mailto:icu-pcb-forum-bounce@xxxxxxxxxxxxx]On Behalf Of sjchar3@xxxxxxxxxxxx Sent: Wednesday, January 17, 2007 3:29 PM To: icu-pcb-forum@xxxxxxxxxxxxx Subject: [PCB_FORUM] change net to vcc pin Group Never had to do this but, I used the nand gate from orcad library. The power and gnd pins are hidden and are hooked to VCC and Gnd. I would like to change VCC net to something else, can i do this without building another part? Thanks Sam _____ <http://pr.atwola.com/promoclk/100122638x1081283466x1074645346/aol?redir=http%3A%2F%2Fwww%2Eaim%2Ecom%2Ffun%2Fmail%2F> Check Out the new free AIM(R) Mail -- 2 GB of storage and industry-leading spam and email virus protection.