[PCB_FORUM] Re: change net to vcc pin

In concept (cadence's allegro schematic), the propertie to redirect a power pin is  "power_group" with value "vcc=+5v" attached to the symbol in schematic.It redirect the pin vcc to +5v.
Maybe it is the same propertie used in capture?

sjchar3@xxxxxxxxxxxx a écrit :
 Group
 Never had to do this but, I used the nand gate from orcad library. The power and gnd pins are hidden and are hooked to VCC and Gnd. I would like to change VCC net to something else, can i do this without building another part?
 
Thanks Sam
Check Out the new free AIM(R) Mail -- 2 GB of storage and industry-leading spam and email virus protection.
----------------------------------------------------------- To subscribe/unsubscribe: Send a message to icu-pcb-forum-request@xxxxxxxxxxxxx with a subject of subscribe or unsubscribe To view the archives of this list go to http://www.freelists.org/archives/icu-pcb-forum/ Problems or Questions: Send an email to icu-pcb-forum-admins@xxxxxxxxxxxxx -----------------------------------------------------------

Other related posts: